The installation of your new bathroom vanity and countertop can transform an outdated bathroom into a contemporary 1. Setting up a vanity and countertop is basic to do and may be bought from any residence improvement store for less than $ 500.
Remove the old Vanity and Countertop
1st turn off the water supplies under the vanity. Next disconnect the supply lines at the valves. Then disconnect the drain pipe at the trap (the j-shaped section underneath the vanity).
Next remove the corner screws which are securing the top of the old vanity to the countertop. The countertop need to then be able to be lifted off of the old vanity.
After the countertop has been separated from the vanity, remove the faucet hardware in case you plan on reusing the existing faucet. Be sure, however, when buying your new vanity countertop that it’ll support the faucet configuration (one hole or 3 holes – as well as the number of inches between the holes – center to center).
After the countertop and faucet have been removed from the work area, unscrew the back and/or side screws that hold the vanity to the wall(s). Then remove the vanity from the bathroom.
Installing the new Vanity and Countertop
Slide the new vanity into the location where the previous vanity resided. Note: you will most likely have to remove/cut away the portion of the back of the new vanity to permit the supply lines and drainage pipe to slide by means of. The jig saw works fine for this effort. Just make the couple of pilot holes with a drill and then use the jig saw to cut out the suitable area.
Once the vanity is in position, you will must square it up with the back or side walls and make certain it sits level. If you can find imperfections in the walls when attempting to square it up (e.g. the walls aren’t straight), you are able to either scribe the vanity or use your tiny piece of trim to hide any imperfections. Scribing involves using a compass and cutting/shaving away a strip of the vanity edge such that the entire length of the cabinet edge sits evenly against the wall.
As a way to level the vanity, shims may be necessary to temporarily hold the vanity in place. Make sure the vanity is level back to front and side to side. Then, using screws fasten the vanity to the walls. Make sure the screws are securely fastened to studs behind the sheetrock.
Once the vanity has been secured, it’s now time to tackle the new countertop.
It is finest to mount the faucet assembly to the countertop just before placing the countertop onto the vanity. Once the faucet/supply lines and drain pipe have been installed to the countertop you’re ready to place the countertop onto the vanity. Nevertheless, it’s greatest to lay a bead of Liquid Nails (caulk adhesive) along the top of the vanity first. This will assist to make certain that the countertop remains securely fastened to the vanity. In some instances, this may possibly be all that’s essential or desired for securing the countertop to the vanity.
Place the countertop on top of the vanity making certain it sits square. Use screws to secure the vanity to the countertop. Generally you’ll find corner blocks on the vanity to secure the screws to the countertop. Make sure, however, that you use screws that can not penetrate through the top of the vanity.
More about bathroom vanities and sinks,visit at cheap bathroom vanities and sinks